Non-woven filter fabric, by the roll

Filter Fabric for French Drains, Drainage and Erosion Control

Filter fabric lets water through and holds soil back, so a drain stays a drain. TERRA is our needle-punched non-woven filter fabric in 4, 6, and 8 oz for French drains, dry wells, retaining wall backfill, and slopes. Also sold as filter cloth or drainage fabric. Free US shipping, no minimum.

Free US shipping, no minimum · Published ASTM data sheets · 4, 6 and 8 oz rolls

Filter fabric job: DOTDAY TERRA non-woven geotextile lining a timber-framed pad as a dump truck drops sand fill
TERRA non-woven holding fines under fill
Filters fines silt stays out of the stone.
Passes water through the whole mat.
Three weights 4, 6 and 8 oz.
Published specs flow, AOS, puncture.
We spec the weight with you.
DOTDAY TERRA non-woven needle-punched geotextile fabric roll
Filter fabric

Filter fabric rolls in 4, 6 and 8 oz

Every roll is TERRA non-woven needle-punched filter fabric. Pick the weight by depth, soil, and stone size. Prices per roll; free US shipping, no minimum.

4oz - 3 ft x 50 ft$58.49
Drainage & filtration
6oz - 3 ft x 50 ft$89.99
Separation, retaining walls
8oz - 6 ft x 50 ftSold out
Heavy stabilization, road baseRequest 8 oz pricing

4 oz suits shallow yard drains and downspout runs. 6 oz covers most footing drains and retaining wall backfill. 8 oz is for deep or clay trenches, coarse stone, and slopes. Not sure? Send us the job and we will spec it.

The problem

Why drains without filter fabric quit

A French drain or dry well works because of the empty space between the stones. Fine soil washes into that space with every rain until water has nowhere to go. Drainage filter fabric is the layer that stops it.

No fabric at all.Silt migrates into the gravel from the trench walls, and the stone slowly turns into packed dirt.
Woven weed barrier in the trench.Woven fabric is built to block, not filter. In a drain the weave blinds over with fines and water stops passing.
Too light for the stone.Sharp drainage stone and deep backfill can puncture a light sheet. Heavier weights add puncture strength.
Not fully wrapped.Fabric only on the bottom leaves the sides and top open to soil. Line the walls and fold it over the stone.
Cross-section diagram of a French drain wrapped in filter fabric: fabric lining the trench, stone base, perforated pipe, washed drainage stone, 12 inch top overlap and backfill
Wrap the whole core. Fabric on the bottom only leaves the sides and top open to soil. See French drain fabric

Filter fabric weights, lab values side by side

Lab value (ASTM)TERRA 4 ozTERRA 6 ozTERRA 8 oz
Mass per unit area (D5261)4.0 oz/yd²6.0 oz/yd²8.0 oz/yd²
Water flow rate (D4491)4,800 l/min/m²4,000 l/min/m²3,300 l/min/m²
Apparent opening size, AOS (D4751)0.20 mm0.20 mm0.16 mm
CBR puncture (D6241)300 lb400 lb500 lb
Grab tensile (D4632)100 lb160 lb205 lb
Best filter fabric jobShallow yard drains, downspout runsFooting drains, retaining wall backfillDeep or clay trenches, slopes, road base
Bar charts comparing TERRA 4 oz, 6 oz and 8 oz filter fabric on water flow rate, CBR puncture resistance and grab tensile strength
Lighter weights flow more water. Heavier weights take sharper stone and deeper backfill. See the technical data sheets
DOTDAY TERRA 6 oz 3 ft x 50 ft non-woven filter fabric rolls strapped at the factory
How it works

Needle-punched felt: filters fines, passes water

TERRA is made by needle-punching polypropylene fibers into a felt-like mat. Water moves through the thickness of the mat in every direction, while the tight, random fiber paths hold soil fines on the outside. That is the job a filter fabric does: keep the drain stone clean so water keeps moving to the pipe or outlet.

  • Apparent opening size 0.20 mm at 4 and 6 oz, 0.16 mm at 8 oz (ASTM D4751)
  • Water flow 4,800, 4,000, and 3,300 l/min/m2 (ASTM D4491)
  • CBR puncture 300, 400, and 500 lb (ASTM D6241)
Diagram showing non-woven filter fabric passing water into clean drain stone while holding soil fines on the soil side
Needle-punched felt passes water through the whole mat and holds soil fines on the outside.

Filter fabric vs woven weed barrier vs no fabric

PropertyNo fabricWoven weed barrierTERRA filter fabric
Built forNothing, stone meets soilBlocking weeds under mulchFiltration and drainage
Holds soil fines backNoBlinds over with finesYes
Water pathThrough stone until it siltsThrough gaps in the weaveThrough the whole mat
Right placeNever in a drainBeds and rows, under mulchFrench drains, dry wells, walls, slopes
Trench comparison of no fabric, woven weed barrier and TERRA non-woven filter fabric, showing which keeps water moving in a drain
In a drain, woven fabric blinds over with silt. Non-woven filter fabric keeps passing water. Shop TERRA filter fabric

Where drainage filter fabric goes

French drains

Line the trench, build the stone and pipe inside, and wrap it closed.

French drain fabric guide

Dry wells and downspout drains

Wrap the stone pit so roof water soaks away instead of silting the void.

Use TERRA 4 or 6 oz

Retaining wall backfill

Separate the drainage stone behind the wall from the soil it holds back.

Retaining wall fabric guide

Slopes and erosion control

Under stone on slopes and banks, the fabric holds soil in place while water drains.

Erosion control fabric guide
Filter fabric weight chooser: TERRA 4 oz for shallow yard drains, 6 oz for footing drains and retaining walls, 8 oz for deep or clay trenches and slopes
Pick the weight by the job.
Watch the install

TERRA filter fabric going into a walkway excavation

An installer unrolls TERRA non-woven filter fabric flat across a walkway excavation before any stone goes in. The fabric sits snug on the soil with no bridged gaps, so fines stay below while water can still drain through. Stone or fill then goes on top as the job moves along.

  • Unroll the fabric flat across the excavation.
  • Keep it snug against the soil, no bridging gaps.
  • Cover with stone or fill as you go.

How to wrap a French drain in filter fabric

  1. 1
    Size the roll
    Fabric width = trench bottom + both side walls + about 12 inches to overlap on top. A 12-inch wide, 12-inch deep trench needs about 4 ft. A 3 ft roll wraps a trench up to about 8 by 8 inches; the 6 ft roll wraps up to about 12 inches wide by 24 inches deep.
  2. 2
    Dig and shape the trench
    Slope the trench to daylight or a sump at about 1 percent fall, and keep the walls clean so the fabric sits flat against soil.
  3. 3
    Line it
    Roll TERRA down the walls and floor, leaving the extra width at the top. Overlap roll ends by 12 inches or more.
  4. 4
    Build the core
    Set a stone base, lay the perforated pipe, and top with washed drainage stone, all inside the fabric.
  5. 5
    Wrap and backfill
    Fold both sides over the stone so the core is fully wrapped, then backfill. The wrap is what keeps soil out.
Six steps to wrap a French drain in filter fabric: dig and grade, line the trench, stone base, perforated pipe, washed stone, wrap and backfill
The French drain wrap in six steps. More on French drain fabric
Real French drain job

Filter fabric in a real French drain

Contractor Cody Adkins spreads clean, washed drainage stone into a trench lined with TERRA non-woven filter fabric, then starts the wrap. Clean stone and a full wrap are what keep a French drain draining.

Read the French drain install guide
Real jobs

Filter fabric on real jobs

Cody Adkins wrapping a French drain in TERRA, and Jeff St Pierre rolling TERRA 8 oz under a paver walkway base in Maine. Jeff's verdict: “The quality was excellent, it was easy to work with, and I'd definitely feel comfortable using it regularly on my projects.”

Clean washed gravel inside a French drain trench lined with DOTDAY TERRA non-woven filter fabric along a fence
Washed stone sitting inside the TERRA liner, ready for the fold-over.Photo: Cody Adkins (@codyadkinsofficial)
Cody Adkins folding DOTDAY TERRA non-woven filter fabric over the stone to wrap a French drain
Folding the fabric over the stone so soil stays out of the drain.Photo: Cody Adkins (@codyadkinsofficial)
Jeff St Pierre rolling out DOTDAY TERRA 8 oz non-woven geotextile on a prepared paver walkway base in Maine
TERRA 8 oz going down on a walkway base before the stone.Photo: Jeff St Pierre, Groundwork by Jeff. See the full project

Filter fabric, common questions

What is filter fabric?

A permeable non-woven geotextile that lets water pass while holding soil fines back. It lines French drains, dry wells, and wall backfill so the stone stays clean. DOTDAY TERRA is a needle-punched non-woven filter fabric in 4, 6, and 8 oz.

Is filter fabric the same as filter cloth or drainage fabric?

Yes. Filter fabric, filter cloth, drainage fabric, and French drain fabric all describe the same thing: a non-woven geotextile used for filtration and drainage. See our geotextile fabric page for how it fits the wider geotextile family.

Is filter fabric the same as landscape fabric?

No. Most landscape fabric is woven and built to block weeds under mulch. Filter fabric is non-woven and built to pass water while filtering soil. For weed control, see our landscape fabric range instead.

Can I use woven fabric as filter fabric in a French drain?

No. Woven fabric blinds over with silt inside a drain and stops passing water. Use non-woven filter fabric like TERRA in drains.

What weight filter fabric do I need?

4 oz for shallow yard drains and downspout runs, 6 oz for most footing drains and retaining wall backfill, and 8 oz for deep or clay trenches, coarse stone, slopes, and road base.

How wide should filter fabric be for a French drain?

Add the trench bottom width, both side walls, and about 12 inches of overlap on top. A 12-inch by 12-inch trench needs about 4 ft of width. The Fabric Calculator handles the roll count.

Does filter fabric go around the pipe or around the stone?

Around the stone. Line the trench, build the stone base, pipe, and washed stone inside the fabric, then fold it over the top so the whole core is wrapped. A sock on the pipe alone leaves the stone open to soil, and in silt or clay that small filter area clogs sooner.

Which side of filter fabric faces up?

Either side. TERRA is a needle-punched non-woven geotextile, and its orientation does not affect performance.

Can I use filter fabric in clay soil?

Yes, and a full wrap matters most there, because clay sheds very fine particles. TERRA 8 oz is the weight we recommend for deep or clay trenches, and it has the smallest opening size of the three, 0.16 mm (ASTM D4751).

How long does filter fabric last in a French drain?

It comes down to how it goes in. Keep rolls out of direct sun and cover the fabric with stone or soil promptly, since polypropylene geotextile is not built to sit in UV. Use clean washed stone so no fines get built into the drain, and pick a weight heavy enough that sharp stone and backfill do not puncture it.

How much does a roll of filter fabric cover?

The 4 oz and 6 oz rolls are 3 ft x 50 ft, 150 sq ft each. The 8 oz roll is 6 ft x 50 ft, 300 sq ft. In a French drain, a 3 ft roll wraps a trench up to about 8 by 8 inches, and a 6 ft roll up to about 12 inches wide by 24 inches deep. The Fabric Calculator handles the roll count.

Is filter fabric good for erosion control?

Yes, under stone on slopes and banks it holds soil in place while water drains through. TERRA 8 oz is the weight we recommend for slopes and heavier stone.

Where can I see the filter fabric specs?

Flow rate, apparent opening size, CBR puncture, and grab tensile for TERRA 4, 6, and 8 oz are on our technical data sheets page.

Do you ship filter fabric free?

Yes. Every DOTDAY roll ships free in the US with no minimum. For crew and project volumes, request bulk pricing.

Find your fabric

Spec the filter fabric once, drain it for good

Tell us the trench depth, the soil, and the stone, and we will match the TERRA weight and roll count. Contractors, ask about bulk pricing.